Sensor Cosmetic Specifications

After Factory Calibration and/or Corrections are applied (if applicable — dependent on sensor)

Blemish Specifications	Max Number of Defects	Blemish Description
Hot/Dead Pixel defects	Typical 0.0025% Max 0.005%	Any pixel that deviates by ±20% from the average of neighboring pixels at 50% saturation including pixel stuck at 0 and maximum saturated value.
Spot defects	none	Grouping of more than 8 pixel defects within a sub-area of 3x3 pixels, to a maximum spot size of 7x7 pixels.
Clusters defects	none	Grouping of more than 5 single pixel defects in a 3x3 kernel.
Column defects	none	Vertical grouping of more than 10 contiguous pixel defects along a single column.
Row defects	none	Horizontal grouping of more than 10 contiguous pixel defects along a single row.

Test Conditions

General

• Nominal light = illumination at 50% of saturation

• Temperature of camera is 45°C

• At exposures lower than 0.25 second

• At nominal sensor gain (1x)

Dynamic Range Test Conditions

• Exposure 100 µs

• 0% Full Light Level

SNR Measurement Test Conditions

• Exposure 2000 µs

• 80% saturation