Common Specifications

Free running, External triggered, Software trigger through Ethernet or IEEE 1588 Precision Time Protocol (PTP)

Internal – Programmable via the camera API
External  – Timed Trigger or Trigger Width modes supported via I/O

10 s

Programmable in increments of 1 µs (minimum (in µs) is model specific)
Pulse controlled via External Trigger pulse width.

Opto-isolated, 2.4 V to 24 V typical, 7 mA min.
Debounce range from 0 up to 255 µs
Trigger Delay from 0 to 2,000,000 µs

Output opto-isolated:
Aligned to the start of exposure with a programmable delay, duration, and polarity
(using feature Output Line Source = Pulse on: Start of Exposure)

In-Sensor gain (model dependent); Digital gain up to 4x

Yes, with Auto-Exposure and AGC (FPGA Gain)

Color cameras support Bayer output firmware

Support for both Horizontal and Vertical Binning: 1x, 2x, and 4x in FPGA

Programmable LUT (Look-up-table) up to 10-Bit (model/firmware dependent)

Available on all models — up to 4096 entries

Available on color models

1 Counter, and 1 Timer
User programmable, acquisition independent, event generation, may control output I/O pins

Timer to Timestamp images and events (1 μs ticks using Internal Clock, 8 ns ticks when using IEEE1588 ( PTP: Precise time Protocol)

Metadata output at the end of images (also known as GenICam Chunk Data)

Automatic cycling between 64 camera setups

Multiple regions of interest – up to 16

Programming support for multicasting images (requires Multicast host support: refer to the SDK documentation – if supported)

Programmable for up to 2 GenICam Action Commands (requires host support: refer to the SDK documentation – if supported)

Internal generator with choice of static and shifting patterns

Select factory default or either of two user saved camera configurations

12 mm (M42-mount models)

42.5 mm x 59 mm x 59 mm

~ 183 g (XL body with no lens)

via the 10-pin I/O connector, or RJ45 in PoE mode

RJ45

+10 to +36 Volts DC recommended (+10%/-10%)
Power Over Ethernet (PoE Class 3 as per IEEE 802.3af)

2 inputs, opto-isolated
3 outputs, opto-isolated

12.5 W (model-dependent)

Gigabit Ethernet 10/5/2.5/1Gbps (10/100 Mbps are not supported)

PAUSE Frame support (as per IEEE 802.3x)

GigE Vision 2.0 compliant

All Models: -20°C to +60°C  (-4°F to +140°F)
Temperature range specification based on an auxiliary input voltage of +20 to +36 Vdc or PoE.

Any metallic camera mounting provides heat-sinking therefore reducing the internal temperature.

10% to 80% non-condensing

-40°C to +80°C (-40°F to +176°F) temperature at 20% to 80% non-condensing relative humidity