Power over Ethernet (PoE) Support

CAUTION
Connect power via the I/O or PoE, not both. Although the has protection, differences in ground levels may cause operation issues or electrical faults, resulting in camera faults or failure.

• The Genie Nano-10G requires a PoE Class 0 or Class 3 power source for the network if not using a separate external power source connected to pins 1 and 2 of the camera’s I/O Connector.

• To use PoE, the camera network setup requires a powered computer NIC supporting PoE, or a PoE capable Ethernet switch, or an Ethernet power injector.

• Important: When using PoE, the camera’s I/O pin 1 (Camera Power – Ground) must not be connected to I/O pin 3 (General Input/Output Common Ground).

IMPORTANT
When using PoE, the camera’s I/O pin 1 (Camera Power – Ground) must not be connected to I/O pin 3 (General Input/Output Common Ground).